Description

Tactile tiles made of polyurethane with an adhesive layer make it possible to adapt the required area for the visually impaired in a matter of minutes. The properties of the polyurethane tiles and the adhesive, reinforced with a reinforcing polypropylene thread, enable the tactile tiles to be used in areas with high traffic.

Tactile warning tiles (indicator tiles) – with cone-shaped irregularities arranged in a linear arrangement. It is a surface design which aims to draw attention to a hazard or alert a decision point. A warning surface is used in such places as: pedestrian crossings, station and stop platforms, stairs, escalators, lifts.

Visually impaired people can walk on a tactile surface or remain in contact with a cane, safely reaching along the road to their destination. Although the reliefs on the surface of tactile tiles are a few millimetres, they are very easy to perceive.

Advantages of overhead polyurethane tactile tiles:

Type of use: for exterior installation outdoors and for interior installation indoors
Resistant to abrasion
UV resistant
Non-slip surface of the tactile tiles
Easy to perceive tactile reliefs on 5 mm high surface
We deliver floor markers for people with visual impairments – polyurethane tactile tiles all over Ukraine, including Kiev, Lviv, Odessa, Kharkiv, Vinnytsia, Lutsk, Dnipro, Donetsk, Zhytomyr, Uzhhorod, Zaporozhye, Ivano-Frankivsk, Kropivnitsky, Mykolayiv, Poltava, Rivne, Sumy, Ternopil, Kherson, Khmelnytsky, Cherkasy, Lugansk, Chernihiv, Chernivtsi and all other cities and towns in our country.

Laying instructions
One of the advantages of polyurethane tactile tiles is easy installation, when you do not need to remove the floor covering. The polyurethane tactile tiles are glued to a previously prepared, cleaned and degreased surface. Tile, glue and adhesive tape are required for installation. Step-by-step instructions, following which you will ensure long-lasting fixation of polyurethane tactile tiles on any type of surface:

Pre-lay the polyurethane tactile tile in the areas where it will be used in the future. Around it, around its perimeter, stick a masking tape that should not be on top of the tile, but should adhere tightly to its edges. This is necessary to quickly remove any excess glue from the edges of the tile, which may later come out during installation.

Remove the polyurethane tactile tile and remove dust and dirt from the installation area of the tactile tile, degrease the surface! The temperature of the surface on which the polyurethane tactile tile is glued should be at least +10℃

Mix the two components by stirring them together for 3 minutes until a homogeneous mass is obtained. The resulting two-component adhesive must be used within 60-70 minutes, which depends on the temperature